tank pressure

Last, concrete formulae of approximate analysis method for stresses of pressure tank structure are recommended.

最后, 推荐了耐压液舱结构应力近似解析法的具体算式.

Then on the basis of the cylindrical tank hydrodynamic pressure formula, the ESD hydrodynamic pressure formula which may be helpful for the designing is presented by analyzing on the numerical hydrodynamic pressure results from ESD finite element model.

结合圆柱形消化池动水压力公式，通过不同地震作用下动水压力数值计算结果，给出了针对卵形消化池动水压力的计算公式，为工程人员的设计工作提供参考依据。

Modeling and Simulation Research on the intensity modulation function of fiber optic bundle sensors based on fiber pair optically powered handy oil tank pressure sensor

基于单光纤对模型的光纤束调制函数的建模与仿真单光纤传输光推动便携式压力测量仪的研究

An inert pad and purge system normally has a supply regulator and a back pressure regulator to maintain interior tank pressure within a narrow range.

一个惰性气封和吹扫系统通常包括一个进气调节器和一个排放压力调节器，可在小范围内维持储罐压力。

The Mending Method of Cracks on the 5000m 3 Oxygen Tank with Pressure

5000m~3氧气柜裂纹带压修补方法

Shorter suction time and higher suction velocity could be obtained when initial tank pressure was set at 2mH_2O compared with 4mH_2O.

预抽压强为2mH2O时能获得较4mH2O时更短的罐满时间和更高的吸入流速。

The rejuvenation of yeast kept in big tank with pressure should decrease the pressure and remove the fermentation liquid then the precipitated yeast were added with 14 ℃ malt extract culture medium for refreshment.

汉生罐保藏种复壮需先降压，排除发酵液，沉淀的酵母加入温度14℃的麦汁培养基培养复壮。

This paper provides methods of calculating the ship ′ s ballast tank pressure loss. We can provide the theory basis to the ballast pump optimized design.

提供了一种计算船舶压载舱压力损失的方法，为船舶设计或选用更换压载水的压载泵提供参考。

The vent system must keep the tank pressure within the permitted limits during ground pressure refueling.

飞机地面压力加油系统通气能力计算是飞机燃油系统设计的重要环节。

For keeping tank pressure in design range, some of boil off gas need to be released form tank through boil off gas treatment system in order to control tank pressure.

而大型储罐的承压能力是较低的，为了保证储罐内的压力在设计允许范围内，需要通过蒸发气处理系统排出部分蒸发气以控制罐内压力。

In the paper, we introduce the whole perspective and methodology of the gasoline tank pressure measuring and controlling system based on 8031, the paper also states the operation principle of the whole system, the key techniques in designing the hardware circuit and software.

本文介绍了基于8031单片机开发的汽油箱内汽油蒸汽压力测控系统的总体设计思路和方法，阐述了整个测控系统的工作原理、硬件和软件设计及相关技术问题。

When the tank pressure of the gas control valve in the mechanical ventilator pressure within the breathing valve does not move and maintain airtight tank;

当罐内气体的压力在机械呼吸阀的控制压力范围之内时，呼吸阀不动作，保持油罐的密闭性；

From the upper oil cap and cap gasket the oil pressure in the tank tightly inside.

油泵的上部由油箱盖和油箱盖垫片,将油泵紧紧地压在油箱内.

Numerical Model of Fuel Tank Pressure Building up Process in Energy Supply System

挤代加泵抽式能供系统燃料舱增压过程数学模型

The mechanism model is built in the paper. In loading process, cargo tank pressure is kept in certain value by using high duty compressor.

建立了装卸货过程中液舱温度、压力的机理模型，装货过程中利用高负载压缩机对液舱压力进行控制。

A model for calculating the water impact of solid and fluid phases is established and used for comparing gas storge tank, pressure release valve and slowly closed back pressure valve, which further proves the function of the gas tank in reducing water impact pressure.

本文通过建立固液两相流水击计算模型对储气罐、泄压阀、缓闭逆止阀等进行了比较计算，进一步论述了储气罐减缓水击压力的作用。

The air tank includes the body, safety valve, blow-off valve, pressure meter and manhole, etc.

储气罐包括本体, 安全阀, 排污阀, 压力表,人孔等.

The water diversion system of the hydropower station will convey water from regulation pond to the power house through water inlet. The main buildings include water inlet, water diversion tunnel, surge tank, pressure shaft and adits with the total length of 3. 5km.

电站引水系统由进水口从调节池中引水到厂房，主要建筑物包括进水口、引水隧洞、调压井、压力竖井和平洞，全长约3.5km。

Reliability analysis of tank at normal pressure

常压储罐系统可靠性研究

Influence rule of tank pressure on thermal stratification in liquid hydrogen tank

气枕压力对液氢贮箱热分层的影响规律

Installing air surge tank in pressure water system is a new and economically efficient measure to prevent water hammer accident.

压力水系统中设置气压式调压室是防护水锤事故的、新的、经济有效的措施。

In order to ensure ship safety, we must know the ship ′ s ballast tank pressure loss.

为了确保更换压载水时船舶的安全，设计船舶时必须对船舶压载舱压力损失进行计算。

Finite element calculation for seismic stress of vertical oil tank of normal pressure

常压立式储油罐地震应力的有限元计算

Through preliminary analysis of the fault of the system, and aimed at pressure instability of high-pressure water tank and pressure shortage at descaling points, this paper will use the pressure of the descaling system as the main research object to analysis and study.

通过对除鳞系统故障的初步分析，针对高压水除鳞系统的高压水罐的压力不稳定以及除鳞点压力不足的情况，本论文将以除鳞系统的压力作为主要研究对象进行分析研究。

The results indicated that the material conveying capacity and tank pressure increased, the material mass ratio of solid and gas in the outlet decreased with the raising of fluidized air quantity.

试验结果表明，物料输送量和流化罐压力随着流化空气量的增加而增加；流化罐出口物料固气质量比随着流化空气量的增加而减小。

Catastrophe in sudden boosting of LNG tank pressure under thermal attack

热侵袭下液化天然气储罐升压的突变机理

Begin-B-BCD-Check adjustment, operation, low pressure inflator connection , an that tank is firm in the band.

BCD浮力调整装置 - 检查调整, 操作, 低压充气阀的接合, 以及气瓶稳固在固定带里.

A high vacuum in the fuel tank can cause atmospheric pressure to collapse the tank.

燃油箱内的高真空,会引起大气压力压塌油箱.

The effects of different insulation, tank pressure and injection situations on the precooling process were investigated.

研究了输送管壁不同绝热条件、贮箱增压及气体引射对自然循环预冷过程的影响。

The precool rate, feeding speed, tank pressure, precool time will be strictly controlled to protect the equipments and technical pipe from being damaged by the large cold shrinkage, high temperature difference, and high stress.

控制预冷速度、进液速度、储罐压力、预冷时间，可防止产生较大的冷收缩和温差应力而损坏设备与工艺管道。